HomeTag

LoRa PCB - KKPCB

When a LoRa PCB Range Test Changes After Conformal Coating

Table of Contents Why coating can change a range result Protect the antenna boundary before coating Control cleaning, masking, and cure Verify the coated assembly without false comparisons A release checklist for environmental builds A LoRa PCB can meet its bench range target and then behave differently after conformal coating, cleaning, or enclosure sealing. The...

A LoRa PCB Coax Launch for Long-Cable and ESD Paths

Table of Contents Why a cable launch changes the board problem Build the coax transition around a return path Separate ESD energy from the receiver Verify the assembled cable interface Release controls for a long-cable product A long outdoor cable turns a LoRa PCB into more than a radio layout. The coax connector, chassis wall,...

LoRa PCB Depanelization: 6 Controls That Protect Antenna Geometry

Table of Contents Why a sound RF layout can shift at depanelization Choose a panel edge that protects the antenna datum Control holes, rails, and connector loads Make mechanical release part of RF verification A release checklist for production A LoRa PCB can pass schematic review and an antenna tuning check, then lose range after...

The LoRa PCB Power Path That Keeps a Remote Sensor from Going Deaf

Table of Contents Why a quiet receiver can fail under transmit load Partition the power path before routing Keep decoupling and shielding stable through assembly Release power integrity as a production characteristic A remote node built around a LoRa PCB may pass a bench range check and then miss packets when its own transmitter, sensor...